Product Manual

P-9000LT/F Low-Rise Pit Lift 15 P/N 5900022 — Rev. A5 — February 2019
If you need to prepare a recessed surface for the P-9000LTF, use the following diagram as a guide.
Depth of Concrete Cutouts must be 3.15 inches. There must also be 4.25 inches of concrete below
the bottom of the Concrete Cutouts.
Create Chalk Line Guides
Make sure to plan out, in advance, where the P-9000LT is going to go:
• Clearance. If you are install the P-9000LT over a pit, you are restricted as to where you can put
it. Be sure to check beforehand, however, to make sure there is clearance on all sides.
• Console. The Console must be positioned near the Lift; the Hydraulic Lines that come with the
P-9000LT are optimized for up to 30 inches between the Lift and the Console.
• Operator. The operator at the Console
must have a full, unobstructed view of the P-9000LT.
• Power. The Console must also be positioned near an appropriate power source.
• Hydraulic Cylinders on the inside. The two Frames are not interchangeable. The Hydraulic
Cylinders must go on the inside (on the pit side if installing over a pit). The holes in the Platforms for
the optional Lift Arms must go on the outside.
• Set up Chalk Line Guides. Create Chalk Line Guides to make sure the P-9000LT is set up
correctly.