Product Manual

21
TO LOWER THE LIFT
1. Remove all tools or other objects from the lift area.
2. Raise lift off safety locks. Make sure you raise the lift
by at least two inches to allow adequate clearance for the
locks to clear.
3. Conrm safety lock is in unlocked position.
4. Push LOWERING valve handle to lower. Do not
override self-closing lift controls.
5. Remain clear of lift when lowering vehicle. Observe
pinch point warning decals.
6. Remove adapters from under vehicle and arms to full
drive-thru position before moving vehicle.
7. If lift is not operating properly, DO NOT use until
adjustment or repairs are made by qualied lift service
personnel.
MAINTENANCE INSTRUCTIONS
• Always keep bolts tight. Check periodically.
• Always keep lift components clean.
• Always if oil leakage is observed, call local service
representative.
• Always if electrical problems develop, call local
service representative.
• Always replace ALL FAULTY PARTS before lift is
put back into operation.
• Daily: Make a visual inspection of ALL MOVING
PARTS and check for excessive signs of wear.
• Daily: Check Safety Locks to ensure they are in good
operating condition.
• Daily: Check pivot points and hinges for wear.
Replace worn parts as required with genuine
BendPak parts.
• Daily: Inspect adapters for damage or excessive
wear. Replace as required with genuine BendPak
parts.
• Weekly: Lubricate any rollers with general purpose
oil or WD-40. Lubricate arm Hinge Pins with grease.
• Weekly: Check bolts and pins to ensure proper
mounting.
• Monthly: Lubricate locking latch shafts. Push latch
handle several times for oil to penetrate pivot points.
• Semi-Annually: Check uid level of lift power unit and
rell if required per lift installation instructions.
• Replace all caution, warning or safety related decals
on the lift if unable to read or missing. Reorder labels
from BendPak.
• Refer to ANSI/ALI ALOIM booklet for periodic
inspection checklist and maintenance log sheet.
CAUTION!
If you are not completely familiar with automotive lift
maintenance procedures; STOP: Contact factory for
instructions. To avoid personal injury, permit only
qualied personnel to perform maintenance on this
equipment.
WARNING!
When lowering the lift PAY CAREFUL ATTENTION
that all personnel and objects are kept clear.
ALWAYS keep a visual line of site on the lift AT ALL
TIMES. ALWAYS make sure that ALL LOCKS are
disengaged. If one of the locks inadvertently locks
on descent the lift and/or vehicle may disrupt
causing personal injury or death.