Product Manual

4. Tighten each Nut until there is at least 2-3 threads

protruding through the top of the nut. The Cables will

remain loose until start up and nal Cable

adjustments are made. (See Fig. 8.4)

5. After routing the Cables double-check to make sure

all are properly positioned and remain within the grooves

of ALL Sheaves. (See Fig. 8.5 - 8.6)

STEP 9

(Power Unit Installation)

1. Mount the Power Unit to the Mounting Bracket using

the M8 Hex Head Bolts and Nylock Nuts then ll the

reservoir with 12 quarts of 10-WT hydraulic oil or Dexron

III automatic transmission uid. (See Fig. 9.1)

ALL WIRING MUST BE PERFORMED

BY A LICENSED ELECTRICIAN.

Fig 8.4

Fig 8.5

Fig 8.6

Fig 8.3

Fig 9.1

M8 Hex

Bolts

Flex Tube

Bracket

Vibration

Dampener

M8 Nylock

Nuts

Flat

Washers

DO NOT PERFORM ANY MAINTENANCE OR

INSTALLATION OF ANY COMPONENTS

WITHOUT FIRST ENSURING THAT ELECTRICAL

POWER HAS BEEN DISCONNECTED AT

THE SOURCE OR PANEL AND CANNOT BE

RE-ENERGIZED UNTIL ALL MAINTENANCE

AND/OR INSTALLATION

PROCEDURES ARE COMPLETED.