Full Product Manual
Table Of Contents
- MD-6XP Mid Rise Lift
- Table of Contents
- Introduction
- Shipping Information
- Safety Considerations
- Components
- Specifications
- Installation Checklist
- Installation
- Safety Rules
- Tools
- Select a Site
- Planning for Electrical Work (220 VAC only)
- Clearance Around the Lift
- Unloading and Unpacking
- Assemble the Portable Stand
- Attach the Power Unit to the Portable Stand
- Set up the Tow Cart
- Hydraulic Fluid Contamination
- About Thread Sealants
- Connect the Hydraulic Hoses
- Install the Lift Arms
- Connect the Power Unit
- Install a Thermal Disconnect Switch
- Fill the Hydraulic Fluid Reservoir
- Test the Lift
- Final Checklist Before Operation
- Operation
- Maintenance
- Troubleshooting
- Wiring Diagrams
- Labels
- Parts Diagrams
- Maintenance Log
- Maintenance Log
- Automotive Lift Institute (ALI) Store
MD-6XP Mid-Rise Scissor Lift 8 P/N 5900108 — Rev. F2 — April 2021
Installation Checklist
Following are the steps needed to install an MD-6XP Lift. Perform them in the order shown.
☐ 1. Review the installation Safety Rules.
☐ 2. Make sure you have the necessary Tools.
☐ 3. Select the Installation Site.
☐ 4. Planning for Electrical Work.
☐ 5. Check clearances.
☐ 6. Unloading and unpacking.
☐ 7. Assemble the Portable Stand.
☐ 8. Attach the Power Unit to the Portable Stand.
☐ 9. Set up the Tow Cart.
☐ 10. About Hydraulic Fluid Contamination.
☐ 11. About Thread Sealants.
☐ 12. Connect the Hydraulic Hoses.
☐ 13. Install the Lift Arms.
☐ 14. Connect the Power Unit.
☐ 15. Install a Thermal Disconnect Switch (Electrician
required
).
☐ 16. Fill the Hydraulic Fluid Reservoir.
☐ 17. Test the Lift.
☐ 18. Review the Final Checklist.