Product Brochure

HD-7P / HD-7W Four-Post Lifts 65 P/N 5900041 — Rev. M — July 2019
Caster Kit
The Caster Kit includes four assemblies, each of which goes under one of the Lift’s four Posts. When
the Lift is raised by the Caster Kit assemblies, you can move it to the desired location.
Important: Only put the Caster Kit assemblies into position to move the Lift. When you are done
moving the Lift, remove the Caster Kit assemblies.
To move your Lift with the Caster Kit:
1. Raise the Lift to the first Safety Lock and engage it there.
2. Locate the components of the four Caster Kit assemblies.
3. Using the supplied hardware, bolt the four Casters to the four holes in the four Caster Kit Shafts.
4. Take one Shaft and put the open end around the Post, with the Shaft on the inside of the Lift.
The Cradle of the Shaft needs to be directly below the Crosstube.
5. Put the Pin through the holes in the Caster Kit assembly and the Post.
6. Put the Cotter Pin into place on the end of the Pin.
7. Repeat Steps 4 through 6 for the other three Caster Kit Assemblies.
8. Lower the Lift down to the ground.
Make sure the Crosstubes are going into all four Cradles on all four Caster Kit Shafts; this is what
pushes the Bases of the Posts off the ground so that you can move it.
9. Move the Lift to the desired location.
10. Raise the Lift to a locking position and engage it there.
11. Take off all four Caster Kit assemblies.