Product Brochure

HD-7P / HD-7W Four-Post Lifts 64 P/N 5900041 — Rev. M — July 2019
Installing Accessories
The accessories available for your Lift include:
• Tire Stops. Installed at the Front of the Lift. Hold the Tires of the Vehicle in position. BendPak
recommends chocking the rear Tires, so that the Vehicle stays in place. Included with the Lift.
• Ramps. Installed at the Rear of the Lift. Allow Vehicles to be easily driven onto the Runways.
Included with the Lift.
• Caster Kit. Gets your Lift up off the ground so you can move it. Optional.
Other optional accessories include Aluminum Ramps, Aluminum Decks, and a Rolling Oil Drain Pan. All
are shown near the bottom of the HD-7P or HD-7W product page.
Tire Stops
Tire Stops are attached on the Front of the Lift. They prevent the tires of the Vehicle on the Lift from
going too far forward.
To install the Tire Stops:
1. Locate the two Tire Stops, two Tire Stop Pins, and four Rotor Clips.
2. Put one Tire Stop in position between the Tubes attached to the Runway, then put the Tire Stop
Pin all the way through the Tire Stop and the Tubes.
3. Secure the Tire Stop with Rotor Clips on each end of the Tire Stop Pin.
4. Repeat Steps 2 and 3 for the second Tire Stop.
Ramps
Your Lift comes with two steel Ramps, for driving Vehicles onto the Runways.
To install the Ramps:
1. Find the required components: two Ramps, two Ramp Pins, and four Rotor Clips.
2. Put a Ramp into position on the end of a Runway at the Rear of the Lift, with the Tube on the
bottom of the Ramp between the two Tubes on the end of the Runway.
3. Slide a Ramp Pin through the three Tubes, then install Rotor Clips on both ends of the Ramp Pin.
Note: The Ramps are awkward, so you may want to consider having two people install them;
one to hold the Ramp, the other to put the components into place.
4. Repeat Steps 2 and 3 for the other Ramp.