Product Brochure

HD-7P / HD-7W Four-Post Lifts 5 P/N 5900041 — Rev. M — July 2019
Symbols
Following are the symbols used in this manual:
⚠ DANGER Calls attention to an immediate hazard that will result in death or severe injury.
⚠ WARNING Calls attention to a hazard or unsafe practice that could result in death or severe
personal injury.
⚠ CAUTION Calls attention to a hazard or unsafe practice that could result in minor personal
injury, product damage, or property damage.
NOTICE Calls attention to a situation that, if not avoided, could result in product or property
damage.
Tip Calls attention to information that can help you use your product better.
Liability Information
BendPak Inc. assumes no liability for damages resulting from:
• Use of the equipment for purposes other than those described in this manual.
• Modifications to the equipment without prior, written permission from BendPak.
• Damage to the equipment from external influences.
• Incorrect operation of the equipment.
Electrical Information
⚠ DANGER All wiring must be performed by a licensed, certified Electrician. Do not perform
any maintenance until main electrical power has been disconnected from the Lift
and cannot be re-energized until all procedures are complete.
Important electrical information:
• Improper electrical installation can damage the Power Unit motor, which is not covered by the
warranty.
• The Lift uses electrical energy; if your organization has Lockout/Tagout policies, make sure to
implement them after connecting to a power source.
• Use a separate circuit breaker for each Power Unit.
• Protect each circuit with a time delay fuse or circuit breaker:
– For a 208 to 230 VAC,
single phase
circuit, use a 25 amp fuse.
– For a 208 to 230 VAC,
three phase
circuit, use a 20 amp fuse.
– For a 380 to 440 VAC,
three phase
circuit, use a 15 amp fuse.