Product Brochure
Table Of Contents
- HD-7P and HD-7W Manual
- Table of Contents
- Introduction
- Shipping Information
- Safety Considerations
- Components
- Specifications
- Frequently Asked Questions
- Installation Checklist
- Installation
- Being Safe
- Tools
- Planning for Electrical Work
- Selecting an Approach Direction
- Selecting a Power Post Location
- Checking Clearances
- Selecting a Location
- Unloading and Unpacking
- Creating Chalk Line Guides
- Moving the Posts into Position
- Installing the Crosstubes
- About Safety Locks
- Installing the Ladders and Top Cap
- Raising the Crosstubes
- Securing the Ladders
- Removing Sheaves
- Installing the Runways
- Installing the First End of the Flex Tube
- Routing the Lifting Cables
- Working with Compression Fittings and Tubing
- Installing the Air Lines
- Installing the Hydraulic Hose
- Installing the Return Line
- Installing the Power Unit
- Filling the Hydraulic Fluid Reservoir
- Installing the Second End of the Flex Tube
- Installing the Pushbutton Air Valve
- Connecting the Return Line
- Connecting the Hydraulic Hose
- Contacting the Electrician
- Connecting to a Power Source
- Installing a Power Disconnect Switch
- Installing a Thermal Disconnect Switch
- About Effective Embedment
- Anchoring the Posts
- Final Leveling
- Installing Accessories
- Lubricating the Lift
- Performing an Operational Test
- Reviewing the Final Checklist
- Operation
- Maintenance
- Troubleshooting
- Wiring Diagrams
- Labels
- Parts Drawings
- Automotive Lift Institute (ALI) Store
- Maintenance Log
HD-7P / HD-7W Four-Post Lifts 22 P/N 5900041 — Rev. M — July 2019
Installing the Crosstubes
Your Lift has two Crosstubes;
they are similar, but not the same
:
• One with Two
Large
Windows: This Crosstube has two
Large
Windows. Must be installed
at the Pull Box end of the Powerside Runway.
• One with Two
Small
Windows: This Crosstube as two
Small
Windows. Must be installed
adjacent to the Power Post.
Both Crosstubes are hollow, which allows the Lifting Cables to be run through them to the Posts.
Tip It is possible to install the Crosstubes incorrectly in several different ways. Take
your time and get it right the first time.
Both Crosstubes
must
be installed so that the Windows open to the inside of the Lift.
Important: Your Power Post location impacts Crosstube installation. The Crosstube with two Small
Windows
must
be installed next to the Power Post. The location of the Ramps do not
come into play when determining where the Crosstubes get installed.
Crosstubes
must
be installed so that their Windows are on the Powerside Runway side of the Lift.
The following drawing shows the two Crosstube setups based on Power Post location.
Top view. Drawing not to scale. Some components not shown. The location of the Ramps does not
change based on Power Post location, but the Powerside Runway and Crosstube locations do.
Windows are in the Crosstubes; they are shown here at the ends of the Powerside Runway for clarity.