Use and Care Manual
Table Of Contents
- Table of Contents
- Introduction
- Shipping Information
- Safety Considerations
- Components
- Specifications
- Installation Checklist
- Installation
- Reviewing the Safety Rules
- Gathering Your Tools
- Preparing for Electrical Work
- Reviewing the Installation Orientation
- Checking Clearances
- Selecting a Location
- Choosing a Wide or Narrow Configuration
- Installing the Safety Assemblies and Positioning the Safety Lock Cable
- Putting the Equalizing Cables into Position
- About Thread Sealants
- Identifying Hydraulic Fittings
- Routing the Hydraulic Hoses
- Creating Chalk Line Guides
- Anchoring the Posts
- Installing the Overhead Assembly and Safety Shutoff Bar
- Installing the Microswitch
- Completing the Equalizing Cables Installation
- Mounting the Power Unit
- Installing the Safety Lock Cable
- Connecting the Hydraulic Hoses
- Installing the Lift Arms
- Double Threaded Rod Installation
- Leveling
- Contact the Electrician
- Electrical Information
- Wiring the Microswitch
- Connecting the Power Unit
- Installing a Power Disconnect Switch
- Installing a Thermal Disconnect Switch
- Lubricating the Lift
- Review Final Checklist Before Operation
- Leave the Manual with the Owner/Operator
- Perform an Operational Test
- Operation
- Maintenance
- Troubleshooting
- Wiring Diagrams
- Labels
- Parts Drawings
- Automotive Lift Institute (ALI) Store
- Maintenance Log
- Maintenance Log
10AP Series Two-Post Lifts 64 P/N 5900265 — Rev. A10 — September 2023
The figure on the next page illustrates typical lifting points based on Vehicle Frame type.
Typical Lifting Points
⚠ WARNING Before attempting to lift a Vehicle verify:
• The Vehicle Frame is strong enough to support its weight and has not been weakened or
compromised by modification, damage, or corrosion.
• The Vehicle individual axle weight does not exceed one-half the Lift capacity.
• All- Lift Pads/Adapters are in secure contact with the Frame at the Vehicle manufacturers’
recommended Lift Points.
• The Vehicle is stable on the Lift and the center of gravity is not shifted, making the Vehicle off
balance.
• The overhead switch bar will contact the highest point on the Vehicle.