Use and Care Manual
Table Of Contents
- Table of Contents
- Introduction
- Shipping Information
- Safety Considerations
- Components
- Specifications
- Installation Checklist
- Installation
- Reviewing the Safety Rules
- Gathering Your Tools
- Preparing for Electrical Work
- Reviewing the Installation Orientation
- Checking Clearances
- Selecting a Location
- Choosing a Wide or Narrow Configuration
- Installing the Safety Assemblies and Positioning the Safety Lock Cable
- Putting the Equalizing Cables into Position
- About Thread Sealants
- Identifying Hydraulic Fittings
- Routing the Hydraulic Hoses
- Creating Chalk Line Guides
- Anchoring the Posts
- Installing the Overhead Assembly and Safety Shutoff Bar
- Installing the Microswitch
- Completing the Equalizing Cables Installation
- Mounting the Power Unit
- Installing the Safety Lock Cable
- Connecting the Hydraulic Hoses
- Installing the Lift Arms
- Double Threaded Rod Installation
- Leveling
- Contact the Electrician
- Electrical Information
- Wiring the Microswitch
- Connecting the Power Unit
- Installing a Power Disconnect Switch
- Installing a Thermal Disconnect Switch
- Lubricating the Lift
- Review Final Checklist Before Operation
- Leave the Manual with the Owner/Operator
- Perform an Operational Test
- Operation
- Maintenance
- Troubleshooting
- Wiring Diagrams
- Labels
- Parts Drawings
- Automotive Lift Institute (ALI) Store
- Maintenance Log
- Maintenance Log
10AP Series Two-Post Lifts 61 P/N 5900265 — Rev. A10 — September 2023
Optional Accessories
Visit bendpak.com for additional Adapters and Auxiliary Adapters (also called height adapters or
extenders) available adapters include the following:
• Four Short Auxiliary Adapters - 2.25 in. / 56 mm (5215757). Allows you to position the
height of your Auxiliary Adapters to make better contact with Vehicles.
• Four Medium Auxiliary Adapters - 2.5 in. / 63 mm (5215758). Allows you to position the
height of your Auxiliary Adapters to make better contact with Vehicles.
⚠ WARNING You can stack Auxiliary Adapters, but only up to 9 in. If you stack Auxiliary Adapters
above 9 in., the Vehicle could become unstable and slip off the Lift, possibly
damaging the Lift, damaging the Vehicle, and injuring anyone under it.
⚠ WARNING Use the correct Adapters. Do not attempt to lift trucks or other frame type vehicles
with standard Rubber Contact Pads.
⚠ WARNING Never use the Lift with missing or damaged rubber Contact Pads. Always replace
Rubber Contact Pads when worn or damaged.
Quick-Fit Slotted Pinch-Weld Pucks or Pads — Always use slotted Pinch-Weld Pucks
(5210263) or slotted Pinch-Weld Pads (5210254) when lifting Vehicles on Manufacturer Approved
Pinch-Weld Jacking Points. These convenient tear-resistant urethane Adapters simply fit over the
existing round Contact Pads.