Use and Care Manual

10AP Series Two-Post Lifts 5 P/N 5900265 — Rev. A10 — September 2023
Shipping Information
Your equipment was carefully checked before shipping. Nevertheless, you should thoroughly inspect
the shipment before you sign to acknowledge that you received it.
When you sign the bill of lading, it tells the carrier that the items on the invoice were received in good
condition.
Do not sign the bill of lading until after you have inspected the shipment. If any of the
items listed on the bill of lading are missing or damaged, do not accept the shipment until the carrier
makes a notation on the bill of lading that lists the missing or damaged goods.
If you discover missing or damaged goods after you receive the shipment and have signed the bill of
lading, notify the carrier at once and request the carrier to make an inspection. If the carrier will not
make an inspection, prepare a signed statement to the effect that you have notified the carrier (on a
specific date) and that the carrier has failed to comply with your request.
It is difficult to collect for loss or damage after you have given the carrier a signed bill of lading. If this
happens to you, file a claim with the carrier promptly. Support your claim with copies of the bill of
lading, freight bill, invoice, and photographs, if available. Our willingness to assist in helping you
process your claim does not make us responsible for collection of claims or replacement of lost or
damaged materials.
Safety Considerations
Read this entire manual carefully before using your new product. Do not install or
operate the product until you are familiar with all operating instructions and warnings. Do not allow
anyone else to operate the product until they are familiar with all operating instructions and warnings.
⚠ WARNING California Proposition 65. This product can expose you to chemicals including
styrene and vinyl chloride which are on the list of over 900 chemicals identified by
the State of California to cause cancer, birth defects or reproductive harm. Always
use this product in accordance with BendPak’s instructions. For more information,
visit www.p65warnings.ca.gov.
Important Safety Information
When using this equipment, basic safety precautions should always be followed, including:
• Read all instructions. Use only as described in this manual.
• Only operate your Lift between temperatures of 41°F to 104°F (5°C to 40°C).
• Make sure all operators read and understand this Installation and Operation Manual. Keep the
manual near the Lift at all times. The Lift should only be operated by authorized personnel.
Keep children and untrained personnel away from the Lift.
• BendPak recommends referring to the ANSI/ALI ALIS Standard Safety Requirements for
Installation and Service for more information about safely installing, using, and servicing your Lift.
• The Lift should only be operated by authorized personnel. Keep children and untrained personnel
away from the Lift.
• Do not make any modifications to the Lift; this voids the warranty and increases the chances of
injury or property damage. Use only factory-approved attachments.
• Do not use the Lift while tired or under the influence of drugs, alcohol, or medication.
• Do not touch hot parts; you could be burned. Always use care with the equipment.