Use and Care Manual

10AP Series Two-Post Lifts 36 P/N 5900265 — Rev. A10 — September 2023
Remove all four Overhead Assembly Sheaves, their Pins and Cotter Pins from the ends of the
Overhead Assembly pieces. Keep the Sheave components nearby, you will be reinstalling them in
the same order in the next section.
Attach one end of the Safety Shutoff Bar to the Overhead Assembly, as shown below; use the
same type of M10 hardware to secure the other end of the Shutoff Bar.
If you are switching the Safety Shutoff Bar from Narrow to Wide Configuration, loosen the Slider
Set Screws, adjust the Safety Shutoff Bar appropriately, and then re-tighten the Slider Set Screws.
Reference only – do not scale.