Use and Care Manual

10AP Series Two-Post Lifts 26 P/N 5900265 — Rev. A10 — September 2023
Reference only – do not scale.
⚠ WARNING Verify the Cylinder Clamps are positioned at the top of the Lift Head and secured.
Do not operate the Lift if the Cylinder Clamps are not secured on the
Hydraulic Cylinders.
10AP Series model numbers ending with -168 or -181 are supplied with Post Extensions that raise
the height of the Posts and allow you to raise taller Vehicles.
The Post Extensions are slipped over the top of both Posts and then bolted into place.
Reference only – do not scale.
To install the Post Extensions:
Locate the two Post Extensions and
the 4 Hex Head Bolts, 8 Flat
Washers, 4 Split-Lock Washers, and
4 Nuts. Reference the illustration
above for part numbers.
Slide one of the Post Extensions
over the top of one of the Posts.
The opening in the Post Extension
faces the inside of the Lift.
Secure the Post Extension to the Lift
Post, using the hardware listed in the
illustration above.
Slide on the other Post Extension to
the other Lift Post and secure it the
same way.