Use and Care Manual

ManualsBrandsBENDPAK ManualsAutomotive10AP-168 2-Post Vehicle Lift 10000 lbs. Capacity - Clearfloor Design with Adjustable Width with 220V Power Unit Included

Table Of Contents

10AP Series Two-Post Lifts 21 P/N 5900265 — Rev. A10 — September 2023

Move to the Powerside Post, Retrieve the Powerside Safety Weldment (5601516), the two

extension springs (5540047) and four machine screws (5530045), then attach it over the Safety

Latch Support Block that is welded inside the Post, as shown below. Attach the Safety Pivot

Holder (5700404) to the Powerside Post, as depicted in step 7 below.

Reference only – do not scale.

Connect the Pivot Pin and Safety Pivot Holder using the M8 x 25 Machine Screw through the

Powerside Post.