Use and Care Manual

10AP Series Two-Post Lifts 11 P/N 5900265 — Rev. A10 — September 2023
Installation Checklist
Following are the steps needed to install a 10AP Series Two-Post Lift; perform them in this order.
☐ 1. Review the Safety Rules.
☐ 2. Make sure you have the necessary tools.
☐ 3. Plan for Electrical Work.
☐ 4. Review the Installation Orientation.
☐ 5. Review Clearances around the Lift.
☐ 6. Select the Installation Location.
☐ 7. Choose a Wide or Narrow Configuration (do not proceed until you have chosen).
☐ 8. Install the Safety Assemblies and position the Safety Cable.
☐ 9. Put Equalizing Cables into position.
☐ 10. Add Extension Pieces (10AP-168 or 10AP-181 Models only).
☐ 11. Learn about Hydraulic Fluid contamination.
☐ 12. Learn about Liquid Thread Sealant.
☐ 13. Routing the Hydraulic Hoses.
☐ 14. Create Chalk Line Guides for the Posts.
☐ 15. Anchor the Posts.
☐ 16. Prepare and install the Overhead Assembly and Safety Shutoff Bar.
☐ 17. Install the Microswitch.
☐ 18. Install the Equalizing Cables.
☐ 19. Mount the Power Unit (but do not connect it to power yet).
☐ 20. Route and install the Safety Lock Cable.
☐ 21. Connect the Hydraulic Hoses.
☐ 22. Install the Lift Arm Assemblies.
☐ 23. Perform final Leveling.
☐ 24. Contact the Electrician.
☐ 25. Wire the Microswitch (Electrician required).
☐ 26. Connect the Power Unit (Electrician required).
☐ 27. Install the Power Disconnect Switch and Thermal Disconnect Switch (Electrician required).
☐ 28. Lubricate the Lift.
☐ 29. Perform an Operational Test.
☐ 30. Review the Final Checklist.
☐ 31. Leave the Manual at the Lift for the Owner/Operator.