Use and Care Manual
Table Of Contents
- Table of Contents
- Introduction
- Shipping Information
- Safety Considerations
- Components
- Specifications
- Installation Checklist
- Installation
- Reviewing the Safety Rules
- Gathering Your Tools
- Preparing for Electrical Work
- Reviewing the Installation Orientation
- Checking Clearances
- Selecting a Location
- Choosing a Wide or Narrow Configuration
- Installing the Safety Assemblies and Positioning the Safety Lock Cable
- Putting the Equalizing Cables into Position
- About Thread Sealants
- Identifying Hydraulic Fittings
- Routing the Hydraulic Hoses
- Creating Chalk Line Guides
- Anchoring the Posts
- Installing the Overhead Assembly and Safety Shutoff Bar
- Installing the Microswitch
- Completing the Equalizing Cables Installation
- Mounting the Power Unit
- Installing the Safety Lock Cable
- Connecting the Hydraulic Hoses
- Installing the Lift Arms
- Double Threaded Rod Installation
- Leveling
- Contact the Electrician
- Electrical Information
- Wiring the Microswitch
- Connecting the Power Unit
- Installing a Power Disconnect Switch
- Installing a Thermal Disconnect Switch
- Lubricating the Lift
- Review Final Checklist Before Operation
- Leave the Manual with the Owner/Operator
- Perform an Operational Test
- Operation
- Maintenance
- Troubleshooting
- Wiring Diagrams
- Labels
- Parts Drawings
- Automotive Lift Institute (ALI) Store
- Maintenance Log
- Maintenance Log
10AP Series Two-Post Lifts 10 P/N 5900265 — Rev. A10 — September 2023
Model
10AP 10AP-168 10APX 10APX-181
Lifting Capacity 10,000 lbs. / 4,536 kg
Max. Capacity — Front Axle 5,000 lbs. / 2,268 kg
Max. Capacity — Rear Axle 5,000 lbs. / 2,268 kg
A – Max. Rise 69 in. / 1,753 mm 75.5 in. / 1,918 mm
B – Lifting Height w/ Pad
1
73 in. / 1,854 mm 79.5 in. / 2,007 mm
C – Max. Lifting Height
1
82.5 in. / 2,095 mm 89 in. / 2,261 mm
D – Min. Height w/ Pad 4 in. / 102 mm
E – Overall Height
145 in. /
3,683 mm
168 in. /
4,267 mm
157 in. /
3,988 mm
181 in. /
4,597 mm
F – Width Overall (Narrow) 135 in. / 3,431 mm
F – Width Overall (Wide) 145 in. / 3,683 mm
G – Outside Posts (Narrow) 127.5 in. / 3,238 mm
G – Outside Posts (Wide) 137.5 in. / 3,492 mm
H – Inside Posts (Narrow) 108.5 in. / 2,756 mm
H – Inside Posts (Wide) 118.5 in. / 3,010 mm
I – Drive-Thru Width (Narrow) 92. in. / 2,338 mm
I – Drive-Thru Width (Wide) 102 in. 2,592 mm
J – Floor to Top Switch
139.5 in. /
3,540 mm
163.5 in. /
4,155 mm
151.5 in. /
3,850 mm
175.75 in. /
4,464 mm
K – Front Arm Reach (min) 24.5 in. / 622 mm
K – Front Arm Reach (max) 50 in. / 1,270 mm
L – Rear Arm Reach (min) 32 in. / 812 mm
L – Rear Arm Reach (max) 59.25 in. / 1,504 mm
Max. load per Lift Arm 2,500 lbs. / 1,134 kg
Screw Pad Adjustment 2 in. / 51 mm
Time to Full Rise
≈ 45 seconds
Motor
2
220 VAC, 60 Hz, 1 Phase
Sound <70 dB
1
Lifting Height w/Pad is maximum lifting height with Pads adjusted to the lowest setting and no adapter(s). Maximum Lifting
Height is maximum lifting height with Pads adjusted to high setting and with both tall and medium Adapters (optional
equipment) installed.
2
Special voltages available upon request.
3
Lift Arms measured from the pivot center to the end of the Lift Arm.
Specifications subject to change without notice.










