Full Product Manual

ISOMETRIC VIEW
FOR REFERENCE ONLY
DO NOT SCALE
4
2
5
6
1
3
REVISION
REV DESCRIPTION DATE EDITED BY ECO#
F
WAS 1842.5 NOW 1840.5 (pg2), UPDATED
BOM REVISIONS
11/29/2021 TM 01361
G UPDATED BOM REVISION 04/15/2022 CA 01406
H REMOVED (3) 5700699 05/24/2022 CA 01415
NEXT ASSEMBLY
5601850
WHERE USED
10AP
10AP-168
ITEM NO PART NUMBER DESCRIPTION QTY REV
1 5701699 10AP OFF SIDE BARE POST 1 D
2 5700699 SMALL HOSE RETAINER 3 A
3 5735700 10AP, D2, XPR TOP TROUGH SUPPORT 2 D
4 5701785 10AP TOP TROUGH TIE PLATE 1 A
5 5735831 10AP SAFETY LATCH SUPPORT BLOCK 1 E
6 5701802 10AP SAFETY ROLLER CLAMP 1 B
SHEET 1 OF 3
REV
DWG. NO.
A
SIZE
TITLE:
NAME
DATE
CHECKED
DRAWN
H
1645 LEMONWOOD DR.
SANTA PAULA, CA 93060
PROPRIETARY AND CONFIDENTIAL
THE INFORMATION CONTAINED IN THIS DRAWING IS
THE SOLE PROPERTY OF BENDPAK INC. ANY
REPRODUCTION IN PART OR AS A WHOLE WITHOUT
THE WRITTEN PERMISSION OF BENDPAK INC. IS
PROHIBITED.
SM
5620675
10AP OFF SIDE POST
SUBWELDMENT
04/21/2020
DO NOT SCALE DRAWING
1:12
SCALE:
THIRD ANGLE PROJECTION
OR 06/03/2022
DIMENSIONS ARE IN MM
TOLERANCES:
0. = ±1.5
0.0 = ±0.5
SURFACE FINISH 1.6 ISO Ra µm
FOR MACHINED SURFACES
UNLESS OTHERWISE SPECIFIED
REFER TO MODEL FOR ADDITIONAL INFORMATION 1.
BREAK AND DEBURR ALL SHARP EDGES 0.3mm 2.
REMOVE ALL WELD SPLATTER 3.
NOTE: UNLESS OTHERWISE SPECIFIED.