Full Product Manual

ISOMETRIC VIEW
FOR REFERENCE ONLY
DO NOT SCALE
4
5
3
2
1
NEXT ASSEMBLY
5216182
WHERE USED
10AP SERIES
ITEM NO PART NUMBER DESCRIPTION QTY REV
1 5701852 10AP INNER TOP TROUGH CHANNEL 1 A
2 5620679 10AP TOP TROUGH END PLATE SUBWELDMENT 1 C
3 5737173 10AP MICROWITCH STOP BAR HINGE PLATE 1 A
4 5700699 SMALL HOSE RETAINER 5 A
5 5766145 10AP, D2, GP-7, XPR MICROSWITCH BOX 1 D
REVISION
REV DESCRIPTION DATE EDITED BY ECO#
A PRODUCTION RELEASE, DERIVED FROM 5601506 06/07/2022 CA 01417
B
UPDATED BOM REVISION, ADDED MASKING
INSTRUCTIONS
10/03/2022 TM 01449
SHEET 1 OF 3
REV
DWG. NO.
A
SIZE
TITLE:
NAME
DATE
CHECKED
DRAWN
B
1645 LEMONWOOD DR.
SANTA PAULA, CA 93060
PROPRIETARY AND CONFIDENTIAL
THE INFORMATION CONTAINED IN THIS DRAWING IS
THE SOLE PROPERTY OF BENDPAK INC. ANY
REPRODUCTION IN PART OR AS A WHOLE WITHOUT
THE WRITTEN PERMISSION OF BENDPAK INC. IS
PROHIBITED.
CA
5601855
10AP INNER TOP
TROUGH WELDMENT
06/07/2022
DO NOT SCALE DRAWING
1:8
SCALE:
THIRD ANGLE PROJECTION
OR 10/05/2022
DIMENSIONS ARE IN MM
TOLERANCES:
0. = ±1.5
0.0 = ±0.5
SURFACE FINISH 1.6 ISO Ra µm
FOR MACHINED SURFACES
UNLESS OTHERWISE SPECIFIED
REFER TO MODEL FOR ADDITIONAL INFORMATION 1.
BREAK AND DEBURR ALL SHARP EDGES 0.3mm 2.
REMOVE ALL WELD SPLATTER 3.
MASK PIN BEFORE PAINTING UP TO B 4.
DIMENSIONS SHOWN ARE AFTER PAINTING 5.
PAINT GRAY (RAL-7024) 20% GLOSS 6.
NOTE: UNLESS OTHERWISE SPECIFIED.