Full Product Manual

ISOMETRIC VIEW
FOR REFERENCE ONLY
DO NOT SCALE
5
1
3
6
2
7
4
8
6
6
NEXT ASSEMBLY
5216180
WHERE USED
10AP
10AP-168
ITEM NO PART NUMBER DESCRIPTION QTY REV
1 5766372 10AP LIFT HEAD TUBE 1 B
2 5620676
10AP/D2-10 LIFT HEAD SLIDE BLOCK BRACKET
SUBWELDMENT
4 A
3 5737330 10AP SAFETY STOP BLOCK 14 A
4 5620763 10AP LIFT HEAD GUSSET SUBWELDMENT 1 B
5 5737175 10AP LIFT HEAD TOP PLATE 1 B
6 5737174 10AP LIFT HEAD BOTTOM PLATE 1 A
7 5620559
10AP, D2-8F, XPR-9/10 LIFT HEAD CABLE
BUTTON STOP WELDMENT
1 B
8 5731074 10AP LIFT HEAD CLOSEOUT GUSSET 1 A
REVISION
REV DESCRIPTION DATE EDITED BY ECO#
A PRODUCTION RELEASE, DERIVED FROM 5601508 06/07/2022 CA 01417
B
REPLACED 5376170 WITH 5737330, WAS 56 14PL
NOW 46 14PL
07/12/2022 TM 01430
C
ADDED 10mm CUT TO LOWER 5620676,
UPDATED BOM REVISION
09/09/2022 TM 01445
SHEET 1 OF 3
REV
DWG. NO.
A
SIZE
TITLE:
NAME
DATE
CHECKED
DRAWN
C
1645 LEMONWOOD DR.
SANTA PAULA, CA 93060
PROPRIETARY AND CONFIDENTIAL
THE INFORMATION CONTAINED IN THIS DRAWING IS
THE SOLE PROPERTY OF BENDPAK INC. ANY
REPRODUCTION IN PART OR AS A WHOLE WITHOUT
THE WRITTEN PERMISSION OF BENDPAK INC. IS
PROHIBITED.
CA
5601852
10AP LIFT HEAD
WELDMENT
06/07/2022
DO NOT SCALE DRAWING
1:12
SCALE:
THIRD ANGLE PROJECTION
OR 09/14/2022
DIMENSIONS ARE IN MM
TOLERANCES:
0. = ±1.5
0.0 = ±0.5
SURFACE FINISH 1.6 ISO Ra µm
FOR MACHINED SURFACES
UNLESS OTHERWISE SPECIFIED
REFER TO MODEL FOR ADDITIONAL INFORMATION 1.
BREAK AND DEBURR ALL SHARP EDGES 0.3mm 2.
REMOVE ALL WELD SPLATTER 3.
DIMENSIONS SHOWN ARE AFTER PAINTING 4.
PAINT GRAY (RAL-7024) 20% GLOSS 5.
10mm CUT TO LOWER 5620676 2PL ONLY 6.
NOTE: UNLESS OTHERWISE SPECIFIED.