Instructions / Assembly

6
7
4
5
2
1
3
ISOMETRIC VIEW
FOR REFERENCE ONLY
DO NOT SCALE
NEXT ASSEMBLY
5245046
ITEM
NO
PART
NUMBER
DESCRIPTION QTY REV
1 5620624 LR-10000 CYLINDER CLEVIS AND SAFETY WELDMENT 1 D
2 5620626 LR-10000 BASE WELDMENT, R.H. 1 C
3 5620625 LR-10000 BASE WELDMENT, L.H. 1 C
4 5620574 LR-10000 HINGE ARM WELDMENT 2 B
5 5620572 LR-10000 HINGE ARM SUBWELDMENT 2 B
6 5620575 LR-10000 RAMP WELDMENT 1 E
7 5700321 LR-10000 HINGE HOLDER 16 D
REVISION
REV DESCRIPTION DATE EDITED BY ECO#
D UPDATED BOM REVISION 02/25/2019 TM 01052
E
E-001
ADDDED 5737142, UPDATED BOM REVISION
ADDED 20% GLOSS PAINT NOTE
09/30/2019
03/12/2020
CA
CA
01128
01137
F REMOVED 5737142, UPDATED BOM REVISION 07/29/2022 TM 01433
WHERE USED
LR-10000
SHEET 1 OF 4
REV
DWG. NO.
A
SIZE
TITLE:
NAME
DATE
CHECKED
DRAWN
F
1645 LEMONWOOD DR.
SANTA PAULA, CA 93060
PROPRIETARY AND CONFIDENTIAL
THE INFORMATION CONTAINED IN THIS DRAWING IS
THE SOLE PROPERTY OF BENDPAK INC. ANY
REPRODUCTION IN PART OR AS A WHOLE WITHOUT
THE WRITTEN PERMISSION OF BENDPAK INC. IS
PROHIBITED.
TM
5601241
LR-10000 LIFT WELDMENT
02/06/2018
DO NOT SCALE DRAWING
1:25
SCALE:
THIRD ANGLE PROJECTION
OR 08/25/2022
DIMENSIONS ARE IN MM
TOLERANCES:
0. = ±1.5
0.0 = ±0.5
SURFACE FINISH 1.6 ISO Ra µm
FOR MACHINED SURFACES
UNLESS OTHERWISE SPECIFIED
REFER TO MODEL FOR ADDITIONAL INFORMATION 1.
BREAK AND DEBURR ALL SHARP EDGES 0.3mm 2.
REMOVE ALL WELD SPLATTER 3.
DIMENSIONS SHOWN ARE AFTER PAINTING 4.
PAINT GRAY (RAL-7024) 20% GLOSS 5.
5620572 AND 5620574 MUST SWING FREELY 6.
NOTE: UNLESS OTHERWISE SPECIFIED.