Installation manual

BENDIX/KING
KY 196B
VHF COMMUNICATIONS TRANSCEIVER
10570I01.ZIPCDL
Rev 1 January/2000
Page 2-5
2.3.6 MOLEX TERMINAL INSTRUCTIONS
The Molex hand crimpers are available under P/N 071--06041--0000, or from Molex under P/N
6115.
Holding the hand crimpers as shown, release the crimper’s ratchet pawl and open by squeezing
tightly on the handles, and then releasing pressure.
FIGURE 2--2 HAND CRIMPER
Close crimpers until ratchet begins to engage. Then insert the terminal into the jaws from the back
side. (See Figure 2--3 and 2--4) For 24 to 30 AWG wire, it will be necessary to start the crimp in
jaw A and then complete it in jaw B. The terminal is in the correct position when the insulation tabs
are flush with the outside face of the crimp jaws.
JAW TERMINAL WIRE SIZE INSULATION RANGE
A 030-01107-0030 18 TO 24 AWG .110 TO .055
B 030-01107-0030 24 TO 30AWG .055 TO .030
FIGURE 2--3 CRIMP JAWS