Specifications

Programming Memory
Locations
1-9
Ten memory locations exist so
that frequently used frequencies can
be quickly called up and
so that these
same frequencies may be scanned in
the memory scan mode.
Any frequency from 108.00
to
136.975 (135.975 on P/N 069-1026-00
version units) may be entered into any
of the ten Memory Locations, num-
bered
0 through 9. Memory Location 0
is reserved for duplex operation.
Duplex operation is transmitting on
one frequency and receiving on
another frequency.
If duplex operation
is not desired, memory location 0 may
also be programmed with a single
frequency. Refer
to the section
entitled Duplex Operation. To enter a
frequency into Memory Location 1
through 9 the frequency must first be
entered and then stored into the
desired Memory Location. For
example,
to enter the frequency
1 18.90MHz into Memory Location 1 :
First the desired frequency must
be entered. Press the keys on the
keyboard in the following order:
Now that the desired frequency
has been entered, it now must be
stored in Memory Location number 1
as desired. Press the keys on the
keyboard in the following order:
The frequency entered will now
be displayed in the frequency window
and the Program mode will be
annunciated by "Pro" being displayed
in the OBS window. To store the
frequency 118.90MHz into any
Memory Location 1 through 9 press
the corresponding number for that
Memory Location. Example:
To store in Memory Location 1
press the 1 key on the keyboard,
to
store in Memory Location 2 press the
2 key on the keyboard, and so on. In
this case press the number 1 key on
the keyboard. An M along with the
Memory Location number will be
displayed on the left side of the
display indicating the frequency
window is displaying the frequency
stored in that Memory Location. The
frequency, 1 18.90MHz, is now
permanently stored in Memory
Location
1 until it is reprogrammed.
15