Quick Reference Guide System KLN 35A Manual
To create a Flight Plan:
1. Select the active Flight Plan (FPL 0) or one of the stored Flight Plans
(FPL 1 through FPL 9) on the screen.
2. Delete existing waypoints from the Flight Plan as necessary by placing
the cursor (
B) over the identifier, pressing E, and then pressing
F.
3. If you wish to insert a waypoint identifier between two other waypoints,
place the cursor (
B) over the waypoint you wish for the new waypoint
to precede.
4. With the cursor on, enter the desired waypoint identifier and press
F.
5. The waypoint page for the selected identifier will be displayed. If this is
the waypoint you intended to enter, press
F again.
6. Repeat the waypoint entry process as needed for your Flight Plan.
To use a stored Flight Plan:
1. Select the desired Flight Plan page (FPL 1 through FPL 9)
2. Press the
B button to turn on the cursor over Use?.
3. If you wish to use the Flight Plan in the order displayed, press
F. If
you wish to reverse the Flight Plan and use it, rotate the right outer knob
one stop clockwise, putting the cursor over Use? Inverted? and press
F. The FPL 0 page will be displayed with your selected Flight Plan.
To create a user-defined waypoint at your present position:
1. Go to a Supplemental page (SUP 1, 2, or 3) and turn on the cursor
(B).
2. Spell out the name of your new user-defined waypoint on the top line,
using the right outer and right inner knobs.
3. Move the cursor to the bottom line of the screen, over Present Pos? and
press
F.
To calculate the winds aloft:
1. Use the CAL 3 page to calculate the present pressure altitude.
2. Use the CAL 5 page to calcu-
late the present true airspeed
(TAS).
3. Turn to the CAL 6 page and
enter the present aircraft head-
ing. The headwind or tailwind
component of the wind, and the
wind vector (direction and
speed) will be displayed on the
last two lines of the CAL 6 page (figure 10).
-5-
APT VOR NDB SUP ACT NAV FPL CAL SET OTH
17.6nm TAS: 136kt
SGJ Hdg: 025°
>Leg Headwind 002kt
CRSR 110°True 20kt
Figure 10
KLN 35A 5/6/03 11:06 AM Page 1