Instruction manual

TRANSMITTER TIME OUT TIMER
After the ID number is set, the display
annunciator will indicate PRG TX. This is
the duration of the transmitter Time Out
Timer. 0
SEC means the Time Out Timer
is disabled.
Press the
[PRI] key to increase the Time
Out Timer duration by 15 seconds, with a
maximum of 225 seconds (3 minutes, 45
seconds). Press the
[PRI] key again to
change the duration from 225 seconds to
zero.
Press the
[CLR] key to set the Time Out
Timer duration to zero.
Press the
[ENT] key to store the changed
setting and advance to the next section.
Press the
[FCN] key to advance to the
next section if no change is needed, or if a
new setting is only to be cloned, not stored
locally.
C .D SCAN DELAY TIME
After the Time Out Timer is set, the upper
display will indicate
PRG SCN. This is the
scan delay time in seconds.
Press the
[PRI] key to increase the scan
delaytime by .5 seconds, up to 7.5 seconds.
Press the
[PRI] key again to change the
time from 7.5 seconds to 0.
Press the
[CLR] key to reset the scan
delay time to 0.
Press the
[ENT] key to store the changed
setting and advance to the next section.
Press the
[FCN] key to advance to the
next section if no change is needed, or if a
new setting is only to be cloned, not stored
locally.
6 BENDIX/KING