Instruction manual

A .
AUTOMATIC NUMBER IDENTIFICATION (ANI)
_-_-_-----~ ---
FRG
r
Lh EE
I ~__-_-_---~- --
PRG
ID
After entering the programming mode the
LCD will display PRG Ch 00
(Alphanumeric) or PROG CH 0
(7-Segment).
Press the
[FCN] key.
The display will indicatethe AN I ID number
(as many as seven digits may be used).
The ID number can be used for either
radio management or transmitted as a
DTMF tone burst for ANI purposes. The
ANI can be enabled or disabled. See “ANI
ENABLE” on page I0.
If no change is needed for the ID number,
press the
[FCN] key to advance to the
next section.
To enter a new number, press the
[CLR]
key, followed by number keys. The digits
will appear at the right side of the display
and move to the left.
To increase the existing ID number by one
digit, press the
[PRI] key.
Press the
[ENT] key to store the new ID
number and advance to the next section.
If the new ID number will be used only for
cloning, press
[FCN] instead of [ENT] to
advance to the next section. The ID
number will not be stored locally.
Keyboard Programming
5