Instruction manual

EXIT PROGRAMMING MODE
1. Rotate the On/Off/Volume knob on the top of the radio
counterclockwise to the Off position
2. Remove the programming plug.
3. The radio will be in normal operation mode the next time it is turned
on.
SELECTING A GROUP
For a 21 O-channel radio, Channel 0 settings affect one “group” of 14
channels. Each group must be programmed separately. To select a
group for programming, perform the following steps:
t
1. Change the radio from programming
mode to normal operation mode by
turning it off, then on.
In normal operation mode, press the
[#] key to display the current group
number for 5 seconds. Press the [#]
key a second time within 5 seconds to
display the alphanumeric label for the
current group.
2. To select a group to be programmed,
press the [#] key followed by number
keys for the group number. Enter the
selection by pressing the [#] key or
the
[ENT] key, or by waiting 5 seconds.
If an invalid group number has been
selected (for example, group 5) the
LCD will display no group 05. To exit
this mode either turn the radio off,
then on; or enter a valid group number
from the keypad.
3. Enter the programming mode and set
the values. See “Keyboard
Programming” on page 2.
NOTE: The same password code is used for all groups in the radio.
Keyboard Programming
19