User's Manual

2. If a previously unturbocharged compressor is being turbocharged, it is recommended
that the inlet cavity screen 238948 be installed with an inlet gasket (291909) on both
sides of the screen.
3. If a compressor is being turbocharged for the first time and specific turbocharger
data is not available to confirm that the installation is within the stated Bendix
compressor turbocharging parameters, the installation must be tested.
A full vehicle dynomometer can be used to measure turbocharger performance at
maximum engine operating conditions. For this test, temperature and pressure
sensing equipment should be installed at the compressor inlet to verify that the
compressor turbocharging parameters are being met. This equipment can be
installed using two alcohol evaporator compressor inlet adapters (236701). See
Figure 1.