User guide
Table Of Contents
- General Information
- RP1210 adapters
- PC hardware requirements
- Technical Assistance
- Installing Bendix® ACom® Diagnostics
- Using Bendix® ACom® Diagnostics
- Bendix® ACom® Diagnostics 6.5 Windows ECU Status Screen
- Diagnostic Trouble Code (DTC) Screen
- Wheel Speed Sensor (WSS) Screen
- Configuration Screen
- Bendix® Trailer Roll Stability Program® (TRSP®) screen
- Pressures Screen
- Bendix® Trailer Roll Stability Program® (TRSP®) Sensors
- Sensor Calibration
- Component Test Screen
- Installation Test
- Bendix® ACom® Diagnostics 6.5 Adaptive Cruise w/ Braking (ACB) Diagnostics
- ACB Data Log
- Known Issues with Bendix® ACom® Diagnostics 6.5
- 8 -
3. Alternatively the program will detect the ECU. The screen will indicate which Bendix ECU was
found and the technician can select Launch to start Bendix
®
ACom
®
Diagnostics.
Figure 5
4. Any ECU selection can be displayed in the DEMO mode by pressing the Start in Demo mode
button. The Demo mode allows the technician to investigate the program’s features without
communicating with an actual ECU.
Figure 6