User guide
Table Of Contents
- General Information
- RP1210 adapters
- PC hardware requirements
- Technical Assistance
- Installing Bendix® ACom® Diagnostics
- Using Bendix® ACom® Diagnostics
- Bendix® ACom® Diagnostics 6.5 Windows ECU Status Screen
- Diagnostic Trouble Code (DTC) Screen
- Wheel Speed Sensor (WSS) Screen
- Configuration Screen
- Bendix® Trailer Roll Stability Program® (TRSP®) screen
- Pressures Screen
- Bendix® Trailer Roll Stability Program® (TRSP®) Sensors
- Sensor Calibration
- Component Test Screen
- Installation Test
- Bendix® ACom® Diagnostics 6.5 Adaptive Cruise w/ Braking (ACB) Diagnostics
- ACB Data Log
- Known Issues with Bendix® ACom® Diagnostics 6.5
- 36 -
Diagnostic Trouble Code (DTC) Window - ACB Sensor
The DTC screen provides the technician with active and stored DTC information. For the active and stored
DTC information, the windows are two tabs; switch between the two views by clicking on the tab.
Each page has two panes: the first pane displays the DTCs; and the second pane displays
troubleshooting/repair information corresponding to the DTC.
The DTC window will display the SPN (Suspect Parameter Number), FMI (Failure Mode Identifier), Error
Object, Failure Number, Description and Frequency Counter (number of occurrences the fault).
Figure 39
Control Buttons for DTC window:
• The Read button will refresh the DTC information from the ECU
• The Clear button will clear the information from the tab
• The Report button opens a page to allow the technician to input data about the ECU and then
allows the technician to save, email or print a DTC report
• The Service button opens the service data
• The HELP button opens help page for DTC
• The Close button will close the window