User guide
Table Of Contents
- General Information
- RP1210 adapters
- PC hardware requirements
- Technical Assistance
- Installing Bendix® ACom® Diagnostics
- Using Bendix® ACom® Diagnostics
- Bendix® ACom® Diagnostics 6.5 Windows ECU Status Screen
- Diagnostic Trouble Code (DTC) Screen
- Wheel Speed Sensor (WSS) Screen
- Configuration Screen
- Bendix® Trailer Roll Stability Program® (TRSP®) screen
- Pressures Screen
- Bendix® Trailer Roll Stability Program® (TRSP®) Sensors
- Sensor Calibration
- Component Test Screen
- Installation Test
- Bendix® ACom® Diagnostics 6.5 Adaptive Cruise w/ Braking (ACB) Diagnostics
- ACB Data Log
- Known Issues with Bendix® ACom® Diagnostics 6.5
- 21 -
Bendix
®
Trailer Roll Stability Program
®
(TRSP
®
) (If Equipped)
Note: TRSP will be available only if the Electronic Control Unit (ECU) supports TRSP
®
. This test will allow
the technician to check the TRSP sensor installation angle. To begin, the technician will need to select
“installation angle”, then press the Start/Next button to begin the test. Follow the prompts to run the test.
The program will prompt the technician by asking, “Did the ECU respond correctly?” The technician must
then acknowledge if the test was successful by selecting the green check mark indicating “yes”, or the red
circle with a line indicating “no.”
Figure 24
Miscellaneous
This test will allow the technician to evaluate the battery voltage, ABS indicator lamp, and AUX I/O
functions. The function will display the tests available which are supported by the ECU. The technician
must select which function(s) to check, then press the Start/Next button to start the test. Follow the
prompts to complete the evaluation. The program will prompt the technician by asking, “Did the ECU
respond correctly?” The technician must acknowledge by selecting the green check mark indicating “yes”,
or the red circle with a line indicating “no.”
Figure 25