User guide
Table Of Contents
- General Information
- RP1210 adapters
- PC hardware requirements
- Technical Assistance
- Installing Bendix® ACom® Diagnostics
- Using Bendix® ACom® Diagnostics
- Bendix® ACom® Diagnostics 6.5 Windows ECU Status Screen
- Diagnostic Trouble Code (DTC) Screen
- Wheel Speed Sensor (WSS) Screen
- Configuration Screen
- Bendix® Trailer Roll Stability Program® (TRSP®) screen
- Pressures Screen
- Bendix® Trailer Roll Stability Program® (TRSP®) Sensors
- Sensor Calibration
- Component Test Screen
- Installation Test
- Bendix® ACom® Diagnostics 6.5 Adaptive Cruise w/ Braking (ACB) Diagnostics
- ACB Data Log
- Known Issues with Bendix® ACom® Diagnostics 6.5
- 20 -
Modulators
This test allows the technician to check the modulators. The test displays the number of modulators
currently configured in the ECU. To select the modulator to check, simply press the Start/Next button to
start the test. Follow the instructions on the screen. The program will prompt the technician by asking “Did
the modulator respond correctly?” The technician should respond by selecting the green check mark
button indicating “yes”, or the red circle with a line button indicating “no.”
Figure 22
Pressure Sensors
This test will allow the technician to test the various pressure sensors supported by the ECU. Press the
Start/Next button to start the test and follow the instructions. The program will prompt the technician by
asking “Did the ECU respond correctly?” The technician should respond by selecting the green check mark
indicating “yes”, or the red circle with a line indicating “no.”
Figure23