User guide
Table Of Contents
- General Information
- RP1210 adapters
- PC hardware requirements
- Technical Assistance
- Installing Bendix® ACom® Diagnostics
- Using Bendix® ACom® Diagnostics
- Bendix® ACom® Diagnostics 6.5 Windows ECU Status Screen
- Diagnostic Trouble Code (DTC) Screen
- Wheel Speed Sensor (WSS) Screen
- Configuration Screen
- Bendix® Trailer Roll Stability Program® (TRSP®) screen
- Pressures Screen
- Bendix® Trailer Roll Stability Program® (TRSP®) Sensors
- Sensor Calibration
- Component Test Screen
- Installation Test
- Bendix® ACom® Diagnostics 6.5 Adaptive Cruise w/ Braking (ACB) Diagnostics
- ACB Data Log
- Known Issues with Bendix® ACom® Diagnostics 6.5
- 18 -
Sensor Calibration
The Sensor Calibration page allows the Lateral Acceleration Sensor (LAS) to be calibrated. The trailer
needs to be on a level surface for the calibration. Press “Start” to begin the calibration process, use the
“Yes, No, or Cancel” choices to answer any questions. Bendix
®
ACom
®
Diagnostics software can be used
to recalibrate the lateral acceleration sensor, clear any DTCs and display the actual sensor value.
Figure 19
Control Buttons for TRSP Sensors:
• The Start button starts the calibration
• The Yes button is used to acknowledge that the technician is in agreement with the question asked
• The No button is used when the technician disagrees with the question asked
• The Cancel button stops the calibration
• The Close button closes the calibration window