User guide
Table Of Contents
- General Information
- RP1210 adapters
- PC hardware requirements
- Technical Assistance
- Installing Bendix® ACom® Diagnostics
- Using Bendix® ACom® Diagnostics
- Bendix® ACom® Diagnostics 6.5 Windows ECU Status Screen
- Diagnostic Trouble Code (DTC) Screen
- Wheel Speed Sensor (WSS) Screen
- Configuration Screen
- Bendix® Trailer Roll Stability Program® (TRSP®) screen
- Pressures Screen
- Bendix® Trailer Roll Stability Program® (TRSP®) Sensors
- Sensor Calibration
- Component Test Screen
- Installation Test
- Bendix® ACom® Diagnostics 6.5 Adaptive Cruise w/ Braking (ACB) Diagnostics
- ACB Data Log
- Known Issues with Bendix® ACom® Diagnostics 6.5
- 16 -
Pressures Screen
The Pressures screen allows the technician to view and record pressures supplied by the trailer ABS
system. The table below describes which pressures are reported by supported Electronic Control Units
(ECUs). The pressure screen allows the technician to apply the brakes and monitor the pressures.
Figure 17
Control Buttons for Graph:
• The Start button will start the data collection
• The Stop button will stop the data collection
• The Rewind button will rewind the data
• The Forward button will forward the data
•
The graph display can be a line graph (default), a bar graph, or 3D-style
Control Buttons for Pressure Screen:
• The Open file button will open an existing pressure file
• The Load file button will load an existing pressure file
• The Help button will open the Help page
• The Close button will close the screen
Trailer ECU features
TABS-6
Advanced (ADV)
TABS-6
Multi-Voltage (MV)
TABS-6 Advanced
(ADV) Multi-
Channel (MC)
TABS-6 Multi-voltage (MV)
Multi-channel (MC)
Pressure
Values
Available to
View
Supply - P1 No No Yes Yes
Control - P4 Yes Yes Yes Yes
Delivery - P21 Yes Yes Yes Yes
Delivery - P22 No No Yes Yes
Air Bag - P42 Yes No Yes No