Operator`s manual

7.1.4 Q: What additional diagnostic information is available?

A: The external LED part # K075866 is connected via the cable harness as a

separate plug. Please refer to Section C, 4.0, step 7 for details on installation

and location of this LED. The LED functions as described in the table below.

Flashing with pattern will have periods of 0.3 second on and 0.3 second off

repeating every 6 seconds. The number of high pulses in each 6–second

window will be determined by a code. For example if the ash code is 2, the

pattern will be 0.3 second on, 0.3 second off, 0.3 second on, 5.1 seconds

off and repeating.

Alarms Priority External LED See

Note

No Alarms 0 Off -

Second Level Low Pressure (SAL) 6 Pattern ashing

code: 4

SAL Cleared 0 Off -

First Level High Pressure (FAL_H) 4 Pattern ashing

code: 2

First Level Low Pressure (FAL_L) 3 Pattern ashing

code: 2

FAL Cleared 0 Off -

High Temperature 7 Pattern ashing

code: 5

High Temperature Cleared 0 Off -

Sensor Diagnostic Trouble Code (DTC) Set 2 Pattern ashing

code: 1

Sensor DTC Cleared 0 Off -

ROM To Both Copy Performed 10 Pattern ashing

code: 7

Set Up DTC 5 Pattern ashing

code: 3

Set Up DTC Cleared 0 Off -

Factory To Custom Copy Performed 9 Pattern ashing

code: 7

Custom To Factory Copy Performed 8 Pattern ashing

code: 7

Watchdog Reset 11 Pattern ashing

code: 8

Sensor Battery Low Alert 1 Pattern ashing

code: 6

Table 5