Operator`s manual

Step 3. Mount the SmarTire Trailer-Link

™

ECU against the bracket by using

the two provided hex bolt sets. Ensure that the ECU module’s at top is

facing parallel to the trailer tires with the harness connector facing away from

the driving direction. See mounting example below; arrow shows driving

direction of the trailer.

Figure 15

Step 4. Find the ABS power supply on the underside of the trailer. This power

supply is usually located just ahead of the trailer axles along the frame or

directly next to the ABS module. Free the connector of any dirt and debris

and wipe down the ABS connection joint with a dry cloth before moving on.

Lift the plastic locking tab slightly to pull the ABS power splice connection

apart. Be careful as this tab can break off easily if pushed up too far!

Step 5. Interconnect the SmarTire Trailer-Link ABS-Power Splice Harness

Part No: K075867 with the original ABS power supply. Ensure the locking tab

is re-engaged and that the connector plugs are greased with the supplied

dielectric grease.