Operator`s manual
13
IMPORTANT
READ THESE INSTRUCTIONS PRIOR TO INSTALLATION
This SmartTire Trailer-Link
™
TPMS kit is pre-programmed and ready to use,
subject to your application:
● The sensors have been PRE-ASSIGNED TO WHEEL POSITIONS and
are identied on each unit with a position label (P1, P2, P3, etc.) – install
the sensors as shown in Figure 1.
● Default values have been assigned to each axle for the following
(depending on kit conguration):
◊ Cold Ination Pressure (CIP) – preset to 100 PSI
◊ First Alert Level (FAL) – preset to ±15% from expected (temperature
compensated)
◊ Second Alert Level (SAL) – preset to -20% from CIP
◊ High temperature alert – 185°F (85°C)
Figure 2