User's Manual

17
REMOVING THE BENDIX
®
EC-60
™
CONTROLLER ASSEMBLY
1. Turn vehicle ignition off.
2. Remove as much contamination as possible prior to
disconnecting electrical connections.
3. Note the Bendix EC-60 controller assembly mounting
position on the vehicle.
4. Disconnect the electrical connectors from the Bendix
EC-60 controller.
5. Remove and retain the mounting bolts that secure the
Bendix EC-60 controller.
CAUTION
The VIN of the vehicle is stored in the ECU internal
memory, and is cross-checked by the ECU using
information obtained from other vehicle controllers.
If the VIN stored in the ECU does not match the VIN
obtained from the other vehicle controller, the ECU will
generate an ECU Internal VIN Mismatch DTC.
Accordingly, do not switch Advanced controllers from
one vehicle to another.
Troubleshooting: General