User manual

Chapter 3 Hardware Installation

ADVANCED MICRO CONTROLS INC.

Transducer Cable Installation

The transducer cable used with the 2762-17 module must be BELDEN 9731 or an exact

equivalent. Complete cables can be ordered from AMCI with the part number C2TT-(x) where

(x) is the length in feet. A wiring diagram of the C2TT-(x) cable is on the next page, figure 3.4.

If you plan to make your own cables, the required cable and connectors can be ordered from

AMCI. The AMCI part numbers are:

Belden 9731 -

Transducer Cable

MS-14 -

2762-17 Connector

MS-20 -

HTT Transducer Connector

The cable shields must be grounded at the 2762-17 Module

ONLY

The shields must not be connected to the transducer and must be

isolated from the raceway that the cable is installed in. Treat the shield

of the cable as a signal conductor. This practice will eliminate ground

loops that may induce EMI noise into the cable or damage the 2762-17

module.

CAUTION