User manual

Chapter 2 2762-17 Module Description
ADVANCED MICRO CONTROLS INC.
35
Fuse Replacement
There are three fuses on the 2762-17. The Power Fuse is located at the top of the module.
The two Output Fuses are located inside the module.
Power Fuse
If the Power Fuse fails, it can be easily replaced. The factory installed fuse is a 3.5 Amp
fast blow, Littelfuse Inc. part number 22503.5. Fuse kits are available from AMCI. The AMCI
part number is SKF-3. Each fuse kit contains five fuses.
To insure continued and adequate
protection, any replacement fuse must have
a rating of 3.5 Amp Fast Blow. Using a higher ampere rating or
slow blow fuses may not protect the module if the fault
conditions are again applied.
Remove system power before removing or
installing any module in the I/O Chassis.
Failure to observe this warning can result in damage to the
module's circuitry and/or undesired operation with possible
injury to personal.
Power Fuse
3.5A Fast Blow
Figure 2.10 Power Fuse
CAUTION
!
WARNING
!