User manual

Chapter 2 2762-17 Module Description
30
ADVANCED MICRO CONTROLS INC.
Run Profile Submenu,
Running a Move Profile From the Keyboard
As the name implies, you initiate a move profile from this submenu. Move profiles cannot
be initiated while in display mode. You must be in program mode to initiate a move profile.
PLC SERIES
PLC SERIES
[
ENTER
]
Run Profile Menu
Press
[
FUNCTION
]
or
[å]
to advance to the
Jog menu. Press
[ä] to return to the
Positioning Setup menu.
Target Position Parameter
Default: 0
Range: Linear Offset to Linear Offset + FSC†
PLC SERIES
Not in Program Mode
You cannot initiate a move profile when in display
mode. If you try, the 2762-17 displays this error
instead the Positioning Direction parameter.
[
FUNCTION
]
PLC SERIES
Positioning Direction Parameter
Default: Positive Approach
Range: Positive Approach or Negative Approach
Press
[
FUNCTION
]
to return to the Run Profile Menu
After setting the approach, press
[
ENTER
]
to initiate a
move profile. When the profile is complete, the
display changes to one of the five listed on the next
page.
[
ENTER
]
Continued on Pg 2-11