User manual

Chapter 2 2762-17 Module Description

ADVANCED MICRO CONTROLS INC.

The Menu System (continued)

Navigating the Submenus in Display Mode

Once in a submenu, use the [FUNCTION] key to scroll through the parameters. Pressing the

[FUNCTION] key when at the last parameter returns you to the main menu. Press the [ENTER]

key to re-enter the submenu.

You cannot program parameters or initiate a move profile while in display mode. You can

jog the position. The jog submenu displays the current position. Press the [▲] or [▼] keys to

increase or decrease the current position. The position will jog as long as a key is pressed. Use

the [FUNCTION] key to exit the submenu.

Navigating the Submenus in Program Mode

You program most of the parameters in the Transducer Setup and Positioning Setup

submenus. One of the digits will blink when you first enter a parameter display. This shows

the position of the cursor. Use the [!] , and ["] keys to move the cursor and the [▲] and [▼]

keys to change the value of the digit. To quickly set most parameters to zero, press the

[CLEAR] key. Once the parameter is modified, press the [ENTER] key to accept the value. If

the 2762-17 accepts the value the cursor is removed from the display.

The module will only accept valid values for the parameters. If the 2762-17 does not accept

a value it will return the display to the last valid number and move the cursor to the first digit.

The valid range for many parameters is based on the values of other parameters. If the module

does not accept a new value, check the other parameter settings.

Pressing the [FUNCTION] key at any time will remove the cursor if you do not want to

modify the parameter that is on the display. The [FUNCTION] key is also used to scroll to the

next parameter in the submenu.

The Run Profile submenu allows you to initiate a move profile from the module. Simply

program the Target Position and the Positioning Direction. The move profile is initiated when

you press [ENTER] at the Positioning Direction display. When the move profile is complete the

2762-17 will display the final position with all of the digits blinking if it completes

successfully. If it does not complete, the module displays one of several error messages.

Pressing the [CLEAR] key while a move profile is running will immediately stop the profile.

The Jog submenu behaves as it does in display mode. Press the [▲] or [▼] keys to increase

or decrease the current position. Press the [FUNCTION] key to exit the submenu.