User manual

Chapter 1 Introduction to the 2762-17

ADVANCED MICRO CONTROLS INC.

Positioning Setup Parameters (continued)

Retry Value

The Retry Value is only used when a move profile is initiated from the backplane and

specifies the maximum number of attempts the 2762-17 will make to reach the target

position if the first attempt failed.

The Retry Value can be programmed to any value between 1 and 255. The default value is

three. If you program a value greater than 255 or a value of zero, the module responds with

and error message. The Retry Value is programmable from the backplane only. There is no

front panel display for this parameter. You must use a Read Positioning Setup Auxiliary

Command (See Pg. 19) to check its value.