Technical data

TRT800H Installation and Operation
24 Dokument-Nr.: 03.2121.010.71e / Revision: 1.03
4 WIRING
4.1 Conductor Cross-Section
Power, GND: AWG20 (0,62 mm²)
Signals: AWG22 (0,38 mm²)
The conductors must be approved for aircraft use.
4.2 TRT800EM – Address Adaptor
P1
1/9 (blue) Power GND
2 s pare
3 internal use (connection to EEPROM)
4 internal use (connection to EEPROM)
5 Serial Interface out COMM-A (TX-RS232)
6 spare
7 spare
8 (red) + DC Power
10 internal use+)
11 internal use+)
12 Serial Interface in COMM-B (RX-RS232)
13 Suppression – I/O
14 (brown) LIGHT**)
15 Ground Switch *)
TNC Connector XPDR Antenna
*) Ground Switch/
FLY_GND
If a ground switch is connected, in “on-ground“
state pin 15 must be connected to „Power GND“,
otherwise leave Pin 15 open.
**) LIGHT
Notice chapter 2.4.3 Background Illumination!
T
R
T
8
0
0
/
8
0
0
A
/
H