Technical data

TRT800H Installation and Operation
13 Dokument-Nr.: 03.2121.010.71e / Revision: 1.03
2.3 Mounting
• For mounting details/drawing refer to chapter 5 DRAWINGS.
• In cooperation with a maintenance shop, location and kind of the
installation are specified. The maintenance shop can supply all
cables. Suitable sets of cables are available from Filser Electronic
GmbH.
• Select a position away from heat sources. Care for adequate
convection cooling.
• Leave sufficient space for the installation of cables and connectors.
• Avoid sharp bends and wiring close to control cables.
• Leave sufficient lead length for inspection or repair of the wiring of
the connector (containing the memory), so that when the mounting
hardware for the rear connectors is removed, the assembly may be
pulled forward several inches.
• Bend the harness at the rear connectors to inhibit water droplets
(formed due to condensation) from collecting in the connector.
• Remove rotary knobs before mounting:
o Lift off faceplate with an appropriate tool.
o Loosen screw and remove rotary knob.
o Insert cap correctly orientated!
For assembly in panels of a thickness of 3 mm up to 5 mm,
longer screws are needed.
Filser part number: MA6K1102