Specifications

CONFIDENTIAL
Bendix Commercial Vehicle Systems LLC
Elyria, OH 44036
PRODUCT SPECIFICATION - BW-283-PR
SPEC. BW-283-PR
73 SHEETS
SHEET NO. 67
Electrical System Wiring
• Has a moderate amount of nonconductive electrical grease been applied to each
connector pin before installation?
Yes No Don’t Know
• Are all connectors completely latched and seated?
Yes No Don’t Know
• Are the connections tight, clean, and protected against moisture?
Yes No Don’t Know
• Are all connectors protected against paint spray?
Yes No Don’t Know
• Is the wire harness the proper length?
Yes No Don’t Know
• Are the wheel speed sensors connected to the correct pigtail harness lead? (Incorrect
sensor installation may cause a fault Indication or degraded ABS performance)
Yes No Don’t Know
• For multi-channel ABS systems, is the remote modulator relay valve connected to the
correct pigtail harness lead? (Incorrect modulator installation may cause a fault
Indication or degraded ABS performance)
Yes No Don’t Know
• Are wires permitted to come straight out of all connectors for a minimum of 3 inches
before bending?
Yes No Don’t Know
• Is all wiring carefully routed to allow adequate clearance from moving components
(suspension, etc.)?
Yes No Don’t Know
• Is wiring routed away from all sharp edges?
Yes No Don’t Know
• If the wire harness is routed through a frame member, are grommets used to prevent
chaffing?
• Is excess wire properly secured (not wound to form coils)?
Yes No Don’t Know
• Are all wire harnesses secured every 18 inches?
Yes No Don’t Know
• Are all wiring secured by UV-stabilized, non-metallic hose clamps, or bow tie cables
ties?
Yes No Don’t Know
Trailer ABS System Check-Out
• Specific Trailer ABS Tests:
(Refer to the Bendix Trailer ABS Service Data Sheets for diagnostic and configuration
information)
− With power applied to the trailer (constant ignition and/or brake lamp), does the
trailer-mounted and the tractor in-dash (PLC) ABS warning lamp illuminate for
2.5 seconds "ON" as a bulb check and then turn "OFF"? (if the lamp stays
"ON", check for faults)
Yes No Don’t Know
− With a trailer brake application and power applied to the trailer (constant ignition
and/or brake lamp), do the modulator relay valves perform a Chuff Test to
indicate proper installation and function?
Yes No Don’t Know
− Has the Trailer ABS ECU auto-configured to the correct ABS configuration?
Yes No Don’t Know
− Does the Trailer ABS ECU perform ABS as expected? (Road test in safe area,
making an abrupt stop from about 20 MPH to check for proper function. The
wheels should not enter a prolonged lock condition and ABS function should be
audible)
Yes No Don’t Know
Table 17: TABS6 OEM Application Checklist (Cont.)
DOCUMENTO CONTROLADO DE FORMATO ELECTRÓNICO: Antes de utilizarlo se requiere verificar el nivel de revision o la suficiencia.
CONTROLLED ELECTRONIC MEDIA DOCUMENT: Verification of revision level or adequacy is required prior to use.