Specifications

CONFIDENTIAL
Bendix Commercial Vehicle Systems LLC
Elyria, OH 44036
PRODUCT SPECIFICATION - BW-283-PR
SPEC. BW-283-PR
73 SHEETS
SHEET NO. 46
1st
Digit
2nd
Digit
Fault Description Repair Information
J1587
(SID)
J1587
(FMI)
Trailer-Mounted ABS Warning Lamp (AUX7)
12 1 ABS lamp (AUX7) shorted or open
• Check for corroded/damaged wiring or connectors
between the ECU and ABS Warning Lamp (AUX7)
• Verify the following:
- At the 5-pin or 18-pin ECU harness connector:
 Continuity of the ABS Warning Lamp (AUX7)
wiring to the lamp (auxiliary device)
 +12V is not measured at ABS Warning Lamp
(AUX7) lead
- At ABS Warning Lamp (AUX7) connector:
 No continuity of the ABS Warning Lamp (AUX7)
lead to ground
 No continuity from ABS Warning Lamp (AUX7)
lead to any other ECU pin(s)
• Replace/repair ABS Warning Lamp (AUX7) wiring or
components as required
81
3, 4, 5 or
12
J1587 Diagnostic (AUX6)
13 1
J1587 diagnostics (AUX6) shorted or
open
• Check for corroded/damaged wiring or connectors
between the ECU and J1587 Diagnostic (AUX6)
• Verify the following:
- At the 18-pin ECU harness connector:
 Continuity of the J1587 Diagnostic (AUX6) wiring
to the lamp (auxiliary device)
 +12V is not measured at J1587 Diagnostic (AUX6)
lead
- At J1587 Diagnostic (AUX6) connector:
 No continuity of the J1587 Diagnostic (AUX6) lead
to ground
 No continuity from J1587 Diagnostic (AUX6) lead
to any other ECU pin(s)
• Replace/repair J1587 Diagnostic (AUX6) wiring or
components as required
250
3, 4, 5 or
12
Lining Wear Monitoring
14 1 Brake pads worn – replace
• Manually check the condition of the pads on each brake
to establish if any require replacement.
• If no pads require replacement, check the wear sensors
and cables for damage or defects.
• After repairs or if no issues found, then clear faults.
• If faults return, replace the TABS6 Module.
70 1
Table 12: Blink Code – Fault Description & Repair Information (Cont.)
5.4.5 Blink Code Diagnostics – Clear Active Faults Codes
To clear active faults, cycling the brake lamp input five (5) times activates the
TABS6 blink code diagnostics.
With the TABS6 powered and the blink code diagnostics activated for clear active
faults, the fault management clears the active faults in the fault memory. This
method of resetting active faults does not clear the information stored in event
history log, to prevent accidental data loss.
DOCUMENTO CONTROLADO DE FORMATO ELECTRÓNICO: Antes de utilizarlo se requiere verificar el nivel de revision o la suficiencia.
CONTROLLED ELECTRONIC MEDIA DOCUMENT: Verification of revision level or adequacy is required prior to use.