Specifications

CONFIDENTIAL
Bendix Commercial Vehicle Systems LLC
Elyria, OH 44036
PRODUCT SPECIFICATION - BW-283-PR
SPEC. BW-283-PR
73 SHEETS
SHEET NO. 24
Figure 13: TABS6 Wire Harness – Wheel Speed Extension Cable (Ref. Drw. 6000365)
Figure 14: TABS6 Wire Harness – Remote Modulator Extension Cable (Ref. Drw. 5013343)
Figure 15: TABS6 Wire Harness – Diagnostic Extension Cable (Ref. Drw. 5007833)
3.3 WS-24 Wheel Speed Sensor (WSS)
The WS-24 Wheel Speed Sensor (WSS) consists of a coil, pole piece and permanent
magnet, packaged in molded plastic and a stainless steel sheath. It works with an exciter
ring (also referred to as a tone wheel) that is typically pressed on to the hub to provide
wheel speed information to the TABS6 ECU. See BW-260-PR for details regarding the
wheel speed sensor.
The WS-24 WSS is available in both straight and right angle (or 90º) models, in a variety
of lengths with various wire harness connectors.
The WS-24 WSS is typically installed in mounting blocks welded to the axle housing.
The sensor must be installed with a Bendix
®
beryllium copper clamping sleeve (Bendix
®
part number 5012878). The clamping sleeve provides a friction fit between the mounting
block bore and the WS-24. The friction fit allows the sensor to slide back and forth under
force but retain its position when the force is removed. See BW-269-PR for details
regarding the clamping sleeve.
When the WS-24 WSS is inserted completely into the mounting block and the wheel is
installed on the axle, the exciter ring contacts the sensor, causing the sensor to be
2-Pin Additional Sensor Connectors – Receptacle
(Amphenal-Sine P/N 60-54265 or equivalent)
2-Pin Additional Sensor Connectors – Plug
(Amphenal-Sine P/N 60-54266 or equivalent)
3-Pin Modulator Connector – Receptacle
(Tyco P/N 967325-2 or equivalent)
3-Pin Modulator Connector – Plug
(Tyco P/N 967402-2 or equivalent)
7-Pin J1587 Connector – Plug
(Amphenal P/N 34-54152 or equivalent)
4-Pin Diagnostic Connector – Receptacle
(Deutsch P/N DT04-4P or equivalent)
DOCUMENTO CONTROLADO DE FORMATO ELECTRÓNICO: Antes de utilizarlo se requiere verificar el nivel de revision o la suficiencia.
CONTROLLED ELECTRONIC MEDIA DOCUMENT: Verification of revision level or adequacy is required prior to use.