GPS Receiver User Manual

ManualsBrandsBendix Commercial Vehicle Systems ManualsGPSBendix/King Global Positioning System KLN 35A

111

112

113

114

115

116

117

118

119

120

To calculate distance, bearing, and time from waypoint to

waypoint:

1.From the CAL 1 page

(figure 4-51), turn on the cursor

(B). It will appear over a cyclic

field that either displays Wpt

(waypoint to waypoint) or Fpl

(flight plan).

2.For this type of calculation, the

cyclic field should display Wpt.

Press Eto toggle if this is not

the case (figure 4-52).

3.Turn the right outer knob

clockwise to move the cursor to

the "from" waypoint in the upper

right corner of the screen

(figure 4-53).

4.Enter the desired identifier for the

"from" waypoint and press F.

You will be shown the waypoint

page for the waypoint you entered. Press Fagain to approve.

NOTE: On either of the two waypoint fields on this page, you can

select your present position. To do this, press E while the cursor is

on the desired waypoint field. The results will only be displayed

when your KLN 35A is receiving a valid position, or if you happen to

be in the Take Home mode (see section 4.7).

5.With the cursor over the "to"

waypoint, enter the desired

identifier (figure 4-54) and press

Ftwice. The distance in

nautical miles and the bearing will

be displayed on line 3.

6.Use the right outer knob to move the cursor over the

groundspeed field on line 4.

7.Select your estimated

groundspeed for the trip. As you

change it, the estimated time en

route (ETE) calculation will be

updated (figure 4-55).

KLN 35A Pilot’s Guide Advanced GPS Operation

4-15

Effective Date 5/95006-08791-0000 Rev 0

Advanced GPS Operation

Chapter 4