Specifications

11
Telephone: [phone]
11
28. CONTINUOUS OPERATION
While in the run mode, press the key twice to turn the output to
permanently on. The symbol appears in the display.
To revert back to timed operation press the until the symbol
appears in the display.
29. CHANGING AN EVENT
Select the event to be changed with the Programme key. A new set of days
may be selected with Day key just as in initial programming.
Hours and minutes can be changed with the h and m keys
Press the Programme key to store the new programme.
30. TROUBLESHOOTING
Problem: Days are flashing and pressing any key does nothing BUT
key turns output ON and OFF.
Solution: Time of Day and DAY of Week have not been set. This may
occur if the power has been off to boiler for longer than 3 days.
Problem: Time of day was set while holding the key down but the
days are still flashing.
Solution: Current day of the week has not been set.
Problem: It is 10am and an ON event for 8am was entered but the
output symbol is not ON. Display shows the and the
symbols.
Solution: After programming the timer does not look back and will not
take place until the event recurs at 8am tomorrow. In order
to turn the boiler ON use the manual override.