Operator`s manual
2
N
L
E
FOR UNITED KINGDOM ONLY
NOTE: This lead/appliance must only be wired by competent persons
WARNING: THIS APPLIANCE MUST BE EARTHED
IMPORTANT: The wires in this lead are coloured in accordance with the following code:
Green/ Yellow: Earth
Blue: Neutral
Brown: Live (Phase)
As the colours of the wires in main leads may not correspond with the colours marking identified in your
plug/appliance, proceed as follows: The wire which is coloured Green & Yellow must be connected to the
Earth terminal marked with the letter E or by the earth symbol
or coloured Green or Green & Yellow.
The wire which is coloured Blue must be connected to the terminal which is marked with the letter N or
coloured Blue or Black. The wire which is coloured Brown must be connected to the terminal marked with
the letter L or P or coloured Brown or Red. If in doubt, consult the instructions provided with the
equipment or contact the supplier. This cable/appliance should be protected by a suitably rated and
approved HBC mains fuse : refer to the rating information on the equipment and/or user instructions for
details. As a guide, cable of 0.75 mm should be protected by a 3A or 5A fuse. Larger conductors would
normally require 13A types, depending on the connection method used. Any moulded mains connector
that requires removal / replacement must be destroyed by removal of any fuse & fuse carrier and
disposed of immediately, as a plug with bared wires is hazardous if engaged in live socket. Any re-wiring
must be carried out in accordance with the information detailed on this instruction.
TABLE OF CONTENTS
PAGE
WARRANTY 1
CERTIFICATIONS AND PRECAUTIONS 1
Introduction 2
Using your meter 3
OPERATING GUIDELINES 5
Introduction 5
Measurement Techniques 5
Voltage Measurement 8
Current Measurement 11
Resistance Measurement 12
Diode Measurement 13
CALIBRATION 14
Introduction 14
Calibration 14
Performance Tests 15
Display Test 15
Linear Voltage Test 16
Current Test 17
Resistance Test 17
Calibration Adjustments 17
MAINTENANCE AND REPAIR INFORMATION 19
Changing the Input Power Configuration 19
Repair 19
SPECIFICATIONS 20
Optional Accessories 22